跳至主要内容

Fuel tank truck precautions for using

Precautions for using fuel truck:
1.Cleaning tank and pipe strainer before using fuel tanker truck.
2.Regular cleaning pipe strainer.
3.Regular discharging water in anti-freezing groove of oil pump.
4.No idling of oil pump.
5. The water box can not be empty when pump working.
6.Regular draining water in box when vehicle idle.
DFAC refuelling truck
标签：

评论

发表评论

此博客中的热门博文

The Maintenance of LED Advertising Truck

 The generator is an important part of the LED advertising truck , and it is the power supply system of the whole truck. Except for the fixed-point parking of our advertising vehicles and plugging in an external power cord for playback, our generators are needed for power supply at other times. Therefore, in order to do a good job in advertising, we must pay special attention to the maintenance of our advertising truck generators. So how do we maintain our LED advertising truck generator? First of all, we have to regularly check the generator of our advertising truck, especially the inspection of the generator oil, and change the oil frequently. Take out the oil dipstick 20 minutes after it is not started or shut down, wipe the oil dipstick with a clean rag or paper towel, reinsert it into the oil hole for 10 seconds, and then take it out to ensure that the oil reaches the middle and upper parts of the lower and upper marks on the oil dipstick. Secondly, we need ...
发表评论
阅读全文

Welding Process of Fuel Tank Truck

  CLVEHICLES.COM has a tank body welding process for fuel tanker truck . Many users who use oil tankers must also want to know how the tanker is made. Now I will introduce the welding of the oil baffle. Welding of the oil baffle plate of the refueling truck: the main work is the welding of the oil baffle plate in the cylinder body. According to the above, three oil baffle plates are generally arranged inside the 6M long cylinder body, and the cylinder body is divided into four compartments. Each oil baffle plate The plate must be intermittently welded with the cylinder body. If it is a separate tank, the oil baffle will be replaced by a partition, and continuous welding must be carried out. The length of each girth weld is based on the aforementioned 6-7.5M length. The continuous welding is calculated according to half of the welding length. The total welding length of this station is about 20M, and the welding speed is calculated at 5mm/s. The welding time is about...
发表评论
阅读全文
Sprinkler truck maintenance in low temperature: 1、 When starting, pay attention to moderate heat:it is a good habit to start a moderately hot truck before starting the car. First idle for about 1 minute, then let the car run slowly for a long distance. The long-term in-situ hot car will increase fuel consumption; Operating the air conditioner at idle seed consumes fuel in particular. 2.When driving, pay attention to gentle refueling, and avoid stepping on the throttle. Cooling system, check the water tank, water pump and belt, water pipe, water supply tank and other components regularly in low temperature weather, especially for suction pump. If there is damage or malfunction, it is best to promptly, repair or replace. 3.Avoid low-speed at high-speed driving: sprinklers should avoid low-speed at high-speed driving, in addition to easy to lose grip, the engine speed is too high, it will be a little”only drink oil does not walk”. 4.Chassis: it is best t...
发表评论
阅读全文